Parallel RLC Resonant Tank Circuit

Parallel RLC Resonant Tank

A parallel RLC circuit connects a resistor, inductor, and capacitor across the same two nodes. Around resonance, the inductor and capacitor exchange energy and their reactive currents largely cancel at the source. The remaining loss resistance controls the sharpness of the response. This small schematic is useful for explaining tank circuits, selective loads, and the difference between parallel and series resonance. The source is shown as an AC test signal; in a real oscillator, an active device supplies the sustaining energy. Choose real component values and include coil resistance, loading, and parasitic capacitance when the design will be built. Record the expected resonant frequency beside the drawing.

النوع مخطط دائرة كهربائيةالمعيار IEEE Std 315 / ANSI Y32.2المحرّك schematex-circuitآخر تحديث 24‏/9‏/2026

الطلب

“Draw a parallel RLC resonant tank with a 1 MHz AC source, a 25 µH inductor, a 1 nF capacitor, and a 1 kΩ loss resistor.”

جرّب إذنChange the capacitor to 470 pF.Add a 10 kΩ load resistor.

ما الذي يتضمنه هذا الرسم

اقرأ القرارات الكامنة وراءه.

01Topology

Place R, L, and C across the same two nodes.

02Drive

Use a small AC source for frequency analysis.

03Loss

Model damping with a parallel resistor.

Use to show a parallel resonant tank or a basic tuned load.

تصفّح جميع قوالب مخطط دائرة كهربائية ←

الأسئلة الشائعة

أسئلة شائعة

What is parallel resonance?

It is the frequency where a parallel inductor and capacitor have opposing reactive currents, producing high input impedance.

What sets the resonant frequency?

Inductance and capacitance set it approximately as 1 divided by 2π times the square root of LC.

Why add a resistor?

It represents losses or loading that limit the circuit Q.