Double-Acting Cylinder Control Circuit

Double-Acting Cylinder Control

A double-acting pneumatic cylinder needs air applied to either side of its piston. This electro-pneumatic control circuit shows the electrical side of that arrangement: a protected 24 VDC supply, an emergency-stop contact, two momentary commands, and the two coils of a 5/2 directional valve. Pressing Extend energizes the first coil; pressing Retract energizes the second. The valve and cylinder’s pneumatic ports are normally documented beside this control schematic. Add end-of-stroke sensors, relay interlocks, or PLC outputs when the actuator must run automatically. Keep both commands mutually safe so the valve is not asked to move in conflicting directions. Mark each coil with the installed valve designation.

유형 회로도표준 IEEE Std 315 / ANSI Y32.2엔진 schematex-circuit업데이트됨 2026. 9. 24.

요청 내용

“Draw a 24 V electro-pneumatic control circuit with an E-stop, extend and retract pushbuttons, and two 5/2 valve solenoid coils for a double-acting cylinder.”

그렇다면Add limit switches for both cylinder positions.Change the supply to 12 VDC.

이 도면에 담긴 내용

그 이면의 의사결정을 읽어 보세요.

01Supply

Use a protected 24 VDC control supply.

02Stop circuit

Put the E-stop ahead of both commands.

03Valve coils

Use one coil for extend and one for retract.

Use for a simple manually controlled double-acting pneumatic actuator.

모든 회로도 템플릿 보기 →

자주 묻는 질문

What valve controls a double-acting cylinder?

A 5/2 directional valve is a common choice because it alternates pressure and exhaust between the two cylinder ports.

Why use two solenoid coils?

One coil commands extension and the other commands retraction on a double-solenoid valve.

What voltage is common for pneumatic controls?

24 VDC is widely used for industrial control circuits, although the valve coil rating must match the installed supply.