PLC Pneumatic Solenoid Valve Circuit

PLC Solenoid Valve Output

PLC-controlled pneumatic machines use digital outputs to energize the coils on directional control valves. This diagram shows one protected 24 VDC output path: the PLC output drives an interface relay, the relay supplies a 5/2 valve coil, and a diode suppresses the inductive voltage spike when that coil turns off. The isolation relay is useful when the PLC output current or wiring practice calls for an interface. In a complete machine schematic, add the matching retract coil, cylinder sensors, terminal numbers, and the PLC input circuit. Confirm whether the output is sinking or sourcing before wiring the installed hardware. Verify the valve coil polarity before adding suppression.

유형 회로도표준 IEEE Std 315 / ANSI Y32.2엔진 schematex-circuit업데이트됨 2026. 9. 24.

요청 내용

“Draw a 24 V PLC output circuit with a fused supply, PLC output Q0.0, output relay, 5/2 pneumatic valve coil, and a flyback diode.”

그렇다면Add a second PLC output for the retract coil.Change the valve coil label to Clamp extend.

이 도면에 담긴 내용

그 이면의 의사결정을 읽어 보세요.

01Output

Use a PLC output or interface relay to switch the coil.

02Suppression

Put a flyback diode across a DC valve coil.

03Protection

Fuse the valve supply separately.

Use for one DC solenoid valve controlled from a PLC output.

모든 회로도 템플릿 보기 →

자주 묻는 질문

Why use a flyback diode on a valve coil?

It limits the voltage spike created when current through the DC coil is interrupted.

Can a PLC output drive a valve directly?

Yes if its voltage, current, and output type match the coil; otherwise use an interface relay.

What is a 5/2 valve coil?

It is the electrical actuator on a five-port, two-position directional valve commonly used with double-acting cylinders.