需求
“An Arduino Uno wired to two SG90 servos: power and ground from the rails, with pan signal on D9 and tilt signal on D10.”
接著試試Swap the pan and tilt pinsAdd a third servo on D6
這張圖裡有什麼
看懂背後的決策。
01
Using Arduino pins D9 and D10 for pan and tilt PWM signals
02
Powering both servos from the Arduino’s 5V pin shared through the breadboard’s top rail
03
Dedicating the top and bottom rails for power and ground distribution
Use this wiring when building a simple pan-tilt mount without an external servo power supply, provided the total servo current draw is within the Arduino’s 5V regulator limit (typically <500 mA for small servos like the SG90).