D Flip-Flop Propagation Timing

D flip-flop propagation delay timing

A D flip-flop timing diagram compares the clock, reset, input data and registered Q output. Data changes are shown against a common clock, while Q changes after the applicable capture edge to make the propagation delay visible. The reset interval establishes a known starting state before normal operation. This drawing is useful in a classroom, design review or interface specification because it separates the data waveform from the state held by the register. For implementation work, add clock-enable behavior, asynchronous controls, setup and hold windows, and technology-specific delay values where needed. A timing diagram communicates the intended relationship between signals; it does not replace static timing analysis.

種類 タイミングチャート規格 WaveDrom-compatible signal descriptionエンジン schematex-timing更新日 2026/9/24

依頼内容

“Draw D flip-flop timing with an eight-cycle clock, reset high for two cycles then low, data changing every two cycles, and Q changing one cycle after the captured data.”

次はこちらAdd a clock-enable signal.Change reset to active low.

この図に含まれるもの

図の背後にある意思決定を読み解く。

01Clock reference

Use a shared clock to align all transitions.

02Reset interval

Show the reset state before normal capture begins.

03Delayed Q

Offset Q transitions from D to illustrate propagation through the flip-flop.

Use as a conceptual timing sketch; use measured delays and setup/hold windows for a sign-off analysis.

タイミングチャートのテンプレートをすべて見る →

よくある質問

What does Q represent?

Q is the registered output of the D flip-flop after it captures the input at its active clock edge.

Why does Q lag D?

A physical flip-flop needs propagation time after a clock edge before its output changes.

Is this a setup-and-hold analysis?

No. It is a conceptual waveform; add explicit timing windows for a setup-and-hold review.