D Flip-Flop Propagation Timing

D flip-flop propagation delay timing

A D flip-flop timing diagram compares the clock, reset, input data and registered Q output. Data changes are shown against a common clock, while Q changes after the applicable capture edge to make the propagation delay visible. The reset interval establishes a known starting state before normal operation. This drawing is useful in a classroom, design review or interface specification because it separates the data waveform from the state held by the register. For implementation work, add clock-enable behavior, asynchronous controls, setup and hold windows, and technology-specific delay values where needed. A timing diagram communicates the intended relationship between signals; it does not replace static timing analysis.

유형 타이밍 다이어그램표준 WaveDrom-compatible signal description엔진 schematex-timing업데이트됨 2026. 9. 24.

요청 내용

“Draw D flip-flop timing with an eight-cycle clock, reset high for two cycles then low, data changing every two cycles, and Q changing one cycle after the captured data.”

그렇다면Add a clock-enable signal.Change reset to active low.

이 도면에 담긴 내용

그 이면의 의사결정을 읽어 보세요.

01Clock reference

Use a shared clock to align all transitions.

02Reset interval

Show the reset state before normal capture begins.

03Delayed Q

Offset Q transitions from D to illustrate propagation through the flip-flop.

Use as a conceptual timing sketch; use measured delays and setup/hold windows for a sign-off analysis.

모든 타이밍 다이어그램 템플릿 보기 →

자주 묻는 질문

What does Q represent?

Q is the registered output of the D flip-flop after it captures the input at its active clock edge.

Why does Q lag D?

A physical flip-flop needs propagation time after a clock edge before its output changes.

Is this a setup-and-hold analysis?

No. It is a conceptual waveform; add explicit timing windows for a setup-and-hold review.